Touch N' GoTM

The Electronic In and Out Board

Manual

Installation

Touch N' Go has been created to occupy minimal space on hard drives through the use of a two part installation process. First, the two Server Disks are installed on a directory that all the workstations can access and that is available whenever you would like Touch N' Go to function. Then, the single Workstation (‘pointer’) Disk is installed on additional locally networked computer workstations. The main software (contained on the Server Disks) is only installed on the Server. The installed workstation program just “points” to the main program on the Server, minimizing occupied space on the workstations. In other words, the workstation program takes up just enough space to direct the workstation computer to where it can find the main program on the Server, and from there it reads the current status of all users. The workstation program then sends information to and receives information from the Server, keeping the Touch N' Go boards continually updated.

You must have a locally networked system in order for this program to function.

		Table of Contents		Touch N' Go		Order Form		30 day free demo
		Next		e-mail		Guest Book		Tips & Tricks

Copyright 1995
All rights reserved
Touch N' Go Systems, Inc.

last modified 10/4/95